Talk:Vice for drill press

Part number 1 -- Inddigital (talk) 22:39, 3 November 2023 (CET)

Xtech2020 review (talk) 20:13, 3 November 2023 (CET) ==

How do you ensure that the jaw moves aligned? An irregular piece can cause it to tilt and get stuck.

--Dev2023 (talk) 21:58, 3 November 2023 (CET)

The vise will be used to hold flat pieces such as bars and plates so it would not be misaligned, however, some wedges between the rails can be considered to improve alignment in the case mentioned.

Part number 1 -- Inddigital (talk) 22:45, 3 November 2023 (CET)

Round 1 closed. No more edits for round 1 permitted.

Permanent link to final Round 1 reviews: https://en.oho.wiki/index.php?title=Talk:Vice_for_drill_press&oldid=48237

Part number 7 -- Inddigital (talk) 22:50, 3 November 2023 (CET)

Aquilesmorillo (talk) 20:41, 3 November 2023 (CET) ==

For this type of manufacturing, I think that a double nut on both sides is unnecessary, with one welding point and two nuts it is enough

--Dev2023 (talk) 22:14, 3 November 2023 (CET)

In this device, we wanted not to use welding at all, however, for practicality an exception was made in the handle. If you are referring to the jaw joint, what you are suggesting makes sense, we will analyze it.