Talk:Vice for drill press
From OHO - search engine for sustainable open hardware projects
Revision as of 22:49, 3 November 2023 by Dev2023 (talk | contribs) (→Part number 1 -- Xtech2020 review (talk) 20:13, 3 November 2023 (CET))
Part number 1 -- Xtech2020 review (talk) 20:13, 3 November 2023 (CET)
How do you ensure that the jaw moves aligned? An irregular piece can cause it to tilt and get stuck.
--Dev2023 (talk) 21:49, 3 November 2023 (CET) The vise will be used to hold flat pieces such as bars and plates so it would not be misaligned, however, some wedges between the rails can be considered to improve alignment in the case mentioned.
Part number 7 -- Aquilesmorillo (talk) 20:41, 3 November 2023 (CET)
For this type of manufacturing, I think that a double nut on both sides is unnecessary, with one welding point and two nuts it is enough