Difference between revisions of "Talk:Vice for drill press"
From OHO - search engine for sustainable open hardware projects
Tag: Manual revert |
(→Part number 1 -- ~~~~: new section) |
||
| Line 7: | Line 7: | ||
For this type of manufacturing, I think that a double nut on both sides is unnecessary, with one welding point and two nuts it is enough | For this type of manufacturing, I think that a double nut on both sides is unnecessary, with one welding point and two nuts it is enough | ||
== Part number 1 -- [[User:Dev2023|Dev2023]] ([[User talk:Dev2023|talk]]) 21:31, 3 November 2023 (CET) == | |||
: The vise will be used to hold flat pieces such as bars and plates so it would not be misaligned, however, some wedges between the rails can be considered to improve alignment in the case mentioned. | |||
Revision as of 22:31, 3 November 2023
Part number 1 -- Xtech2020 review (talk) 20:13, 3 November 2023 (CET)
How do you ensure that the jaw moves aligned? An irregular piece can cause it to tilt and get stuck.
Part number 7 -- Aquilesmorillo (talk) 20:41, 3 November 2023 (CET)
For this type of manufacturing, I think that a double nut on both sides is unnecessary, with one welding point and two nuts it is enough
Part number 1 -- Dev2023 (talk) 21:31, 3 November 2023 (CET)
- The vise will be used to hold flat pieces such as bars and plates so it would not be misaligned, however, some wedges between the rails can be considered to improve alignment in the case mentioned.