Talk:Small water turbine

Part number 1 -- Xtech2020 review (talk) 02:58, 3 March 2021 (CET)

this pdf drawing is missing

Part number B -- Xtech2020 review (talk) 03:06, 3 March 2021 (CET)

Knowledge of the material of the parts, especially metal parts, is required for their construction.

Part number 3.3 -- Xtech2020 review (talk) 03:10, 3 March 2021 (CET)

What is the thickness of this part?

Re: Part number 3.3 -- Inddigital (talk) 01:02, 4 March 2021 (CET)

Hi xtech, your comment has been resolved, please remove the Action Required check mark.

Part number B -- Xtech2020 review (talk) 03:16, 3 March 2021 (CET)

it is recommended to indicate DIN references for fasteners parts

-- Xtech2020 review (talk) 03:20, 3 March 2021 (CET)

It is suggested to include some theoretical estimates of equipment capacity and efficiency.

Re: -- Inddigital (talk) 00:34, 4 March 2021 (CET)

you can get a complete theoretical analysis at: https://dspace.mit.edu/handle/1721.1/27493

Among others, some characteristic curves of the equipment are shown, like this one:

Part number B -- Xtech2020 review (talk) 19:48, 3 March 2021 (CET)

In some items it says cap machine, I think it is a mistake.

Part number B -- Xtech2020 review (talk) 19:50, 3 March 2021 (CET)

the Sheet and Qty columns must be updated

Part number 11.3 -- Xtech2020 review (talk) 19:57, 3 March 2021 (CET)

Specifications of this Standard part are missing

Part number 11.5 -- Xtech2020 review (talk) 19:58, 3 March 2021 (CET)

Specifications of this Standard part are missing

Part number 5 -- Xtech2020 review (talk) 23:19, 3 March 2021 (CET)

For sliding fit moving parts, it is highly recommended to place dimensional tolerances on the dimensions where applicable. In the absence of this, a general value could be specified for these dimensions

Re: Part number 5 -- Inddigital (talk) 01:09, 4 March 2021 (CET)

Thanks for your suggestion, a new thread has been opened in general comments, to highlight this point.

Part number 3 -- Xtech2020 review (talk) 23:44, 3 March 2021 (CET)

test

Part number 7.2 -- Xtech2020 review (talk) 23:55, 3 March 2021 (CET)

this piece does not appear to correspond to any of the original design, it should be removed.

-- Inddigital (talk) 01:06, 4 March 2021 (CET)

In cases of sliding parts, use 0.2 mm as tolerance for diametrical dimensions.

Part number 6.2 -- Xtech2020 review (talk) 01:12, 4 March 2021 (CET)

this pdf drawing is missing

Part number B -- Inddigital (talk) 02:40, 4 March 2021 (CET)

Here, some of the required updates, I will post the rest as soon as possible. Regarding the DIN code for the screws, I will try to keep it as it is, since they are references under American standard with DIN and ISO equivalents easily found.