Talk:Small water turbine
Part number 1 -- Xtech2020 review (talk) 02:58, 3 March 2021 (CET)
this pdf drawing is missing
Part number B -- Xtech2020 review (talk) 03:06, 3 March 2021 (CET)
Knowledge of the material of the parts, especially metal parts, is required for their construction. This applies to the part list and part drawings.
Part number 3.3 -- Xtech2020 review (talk) 03:10, 3 March 2021 (CET)
What is the thickness of this part?
Part number B -- Xtech2020 review (talk) 03:16, 3 March 2021 (CET)
it is recommended to indicate DIN references for fasteners parts
-- Xtech2020 review (talk) 03:20, 3 March 2021 (CET)
It is suggested to include some theoretical estimates of equipment capacity and efficiency.
Re: -- Inddigital (talk) 00:34, 4 March 2021 (CET)
- you can get a complete theoretical analysis at: https://dspace.mit.edu/handle/1721.1/27493
Among others, some characteristic curves of the equipment are shown, like this one:
Part number B -- Xtech2020 review (talk) 19:48, 3 March 2021 (CET)
In some items it says cap machine, I think it is a mistake.
Part number B -- Xtech2020 review (talk) 19:50, 3 March 2021 (CET)
the Sheet and Qty columns must be updated
Part number 11.3 -- Xtech2020 review (talk) 19:57, 3 March 2021 (CET)
Specifications of this Standard part are missing
Part number 11.5 -- Xtech2020 review (talk) 19:58, 3 March 2021 (CET)
Specifications of this Standard part are missing
Part number 5 -- Xtech2020 review (talk) 23:19, 3 March 2021 (CET)
For sliding fit moving parts, it is highly recommended to place dimensional tolerances on the dimensions where applicable. In the absence of this, a general value could be specified for these dimensions
test
Part number 3 -- Xtech2020 review (talk) 23:44, 3 March 2021 (CET)
test
Part number 7.2 -- Xtech2020 review (talk) 23:55, 3 March 2021 (CET)
this piece does not appear to correspond to any of the original design, it should be removed.