Difference between revisions of "Talk:Metal Folding Machine"
From OHO - search engine for sustainable open hardware projects
Line 23: | Line 23: | ||
Interference is observed between the fixed angle and the movable angle, this will make it difficult to turn the bending mechanism. | Interference is observed between the fixed angle and the movable angle, this will make it difficult to turn the bending mechanism. | ||
[ | [https://i.imgur.com/hUl0ZY7.png See the capture] |
Revision as of 07:05, 18 February 2022
-- Xtech2020 review (talk) 05:27, 17 February 2022 (CET)
- Perform the necessary cuts in all metal profiles, as operations prior to welding (corner splices, among others).
- Specifications of all metal profiles and fasteners (DIN code or equivalent information).
- It is recommended to perform a stress analysis to confirm that the equipment will withstand the loads and remain stable.
Part number 5 -- Xtech2020 review (talk) 05:31, 17 February 2022 (CET)
- Complete the rectangle underneath the machine with metal angles.
Part number 4 -- Xtech2020 review (talk) 05:37, 17 February 2022 (CET)
- The length of these bolts appears to be insufficient to secure the clamping profiles.
- Include section views, where the operation of these screws can be observed, this would also facilitate fabrication.
- It is also observed that the bolt is out of phase with respect to its nut.
Part number 2.8 -- Xtech2020 review (talk) 05:48, 18 February 2022 (CET)
These screws do not seem to have an apparent function as such, in case they function as reinforcement, it is suggested to cut a piece of sheet metal or metal profile.
Part number A1 -- Xtech2020 review (talk) 05:53, 18 February 2022 (CET)
Interference is observed between the fixed angle and the movable angle, this will make it difficult to turn the bending mechanism.