Difference between revisions of "Talk:Corn mill"

Revision as of 21:29, 11 September 2020

Part number 4.3 -- Pomelo (talk) 15:46, 3 September 2020 (CEST)

1, 2, 3, probando

Part number 0 -- Pomelo (talk) 21:12, 3 September 2020 (CEST)

Some part names were changed and others were added. These names are of common use and have a good degree of specificity.

Sugerencia: actualizar nombres de partes y archivos correspondientes en el proyecto.

-- Consu (talk) 11:36, 7 September 2020 (CEST)

HOLA TEST--Consu (talk) 11:36, 7 September 2020 (CEST)

Part number 4.8 -- Consu (talk) 11:39, 7 September 2020 (CEST)

HELLO WORLD

Part number 1 -- Pomelo (talk) 16:55, 7 September 2020 (CEST)

Item numbers have to be swapped to match the names of the individual drawings.

Part number 1.2 -- Pomelo (talk) 21:29, 11 September 2020 (CEST)

Avoid specifying tolerances unless you are handling with elements that do need them. For example bearings, pins and axles do need them. There are different tolerances standards. I attached a PDF with general tolerances under DIN - ISO for future reference. The file has gone through ocr so one could select the text to translate.

To the extent of what is possible, avoid using decimals smaller than 0.5 unless strictly necessary. The average DIY/Maker does not have a ruler with partitions smaller than a 1 mm and generally uses a marker that is as thick. And the device itself does not need that level of accuracy for most part.

@@ Line 20: / Line 20: @@
 Item numbers have to be swapped to match the names of the individual drawings.
+== Part number 1.2 -- [[User:Pomelo|Pomelo]] ([[User talk:Pomelo|talk]]) 21:29, 11 September 2020 (CEST) ==
+Avoid specifying tolerances unless you are handling with elements that do need them. For example bearings, pins and axles do need them. There are different tolerances standards. I attached a PDF with general tolerances under DIN - ISO for future reference. The file has gone through ocr so one could select the text to translate.
+To the extent of what is possible, avoid using decimals smaller than 0.5 unless strictly necessary. The average DIY/Maker does not have a ruler with partitions smaller than a 1 mm and generally uses a marker that is as thick. And the device itself does not need that level of accuracy for most part.