Difference between revisions of "Honey Extractor"
(Created page with "{{Projekt |subcat=Honey extractors |projectname=Honey Extractor |projectnameES=Extractor de Miel |projectnameDE=Bienenhonig-Schleuder |kewords=beekeeping, bee, honey, extracto...") |
|||
| Line 1: | Line 1: | ||
{{Projekt | {{Projekt | ||
|Images={{ProjektImages | |||
|projectimage=Oseg-bhe img01.jpg | |||
}}{{ProjektImages | |||
|projectimage=Oseg-bhe img02.jpg | |||
}}{{ProjektImages | |||
|projectimage=Oseg-bhe img03.jpg | |||
}}{{ProjektImages | |||
|projectimage=Oseg-bhe img04.jpg | |||
}}{{ProjektImages | |||
|projectimage=Oseg-bhe img05.jpg | |||
}} | |||
|subcat=Honey extractors | |subcat=Honey extractors | ||
|projectname=Honey Extractor | |projectname=Honey Extractor | ||
| Line 9: | Line 20: | ||
<p>It can be adapted to work with a variable speed drill</p> | <p>It can be adapted to work with a variable speed drill</p> | ||
<p>This project was developed by GARDEN WAY RESEARCH 1975 © and published under licence CC-BY</p> | <p>This project was developed by GARDEN WAY RESEARCH 1975 © and published under licence CC-BY</p> | ||
|licence=CCBY40 | |||
|typeproject=Web | |||
|organization=Garden Way Research | |||
|project_status=active | |||
|maturity=PTT | |||
|design_files_pub=yes | |||
|mechanical_licence=CCBY40 | |||
|assembly_inst_pub=yes | |||
|bill_materials_pub=yes | |||
|contributing_guide_pub=no | |||
|issue_management_system=yes | |||
|versioning_system=yes | |||
|contains_pdf_drawings=yes | |||
|technology_readyness_level=2 | |||
|certificate_requested=No | |certificate_requested=No | ||
}} | }} | ||
Revision as of 02:41, 12 December 2020
|
Honey Extractor Basic Data Category: Honey extractors Keywords: beekeeping, bee, honey, extractor, centrifugal, manual, diy License: CC BY 4.0 Organization: Garden Way Research Project status: Active
Technical documentation Maturity of the project: prototype
Contains PDF-drawings: Yes Assembly instructions are published: Yes Bill of materials is published: Yes
yes yes
|
|
Description
This Honey Extractor is designed to fit a standard, 20 gallon hot dipped galvanized trash can. Drill or cut a hole as close to the bottom of the can as possible, and solder a pipe nipple in place; this is the honey drain. Check the can for water leaks. Resolder joints if necessary.
It can be adapted to work with a variable speed drill
This project was developed by GARDEN WAY RESEARCH 1975 © and published under licence CC-BY
+ General Reviews 