Talk:Solar Water Heater with Serpentine Collector

Part number 1.0 -- Jeefri (talk) 04:40, 13 December 2021 (CET)

Include weld joining details.

Part number 1.2 -- Jeefri (talk) 04:40, 13 December 2021 (CET)

Consider separating the pieces.

Part number 1.3 -- Jeefri (talk) 04:41, 13 December 2021 (CET)

Indicate the thickness of the part.

Part number 1.4 -- Jeefri (talk) 04:41, 13 December 2021 (CET)

Indicate the thickness of the part.

Part number 1.9 -- Jeefri (talk) 04:41, 13 December 2021 (CET)

Indicate the thickness of the part.

Part number 3.0 -- Jeefri (talk) 04:41, 13 December 2021 (CET)

Indicate pipe diameter

Part number 4.0 -- Jeefri (talk) 04:41, 13 December 2021 (CET)

Indicate pipe diameter

Part number C1 -- Jeefri (talk) 04:42, 13 December 2021 (CET)

Consider including technical details on the operation of the project.

Part number C1 -- Dmosquera1968 (talk) 03:30, 22 December 2021 (CET)

Could add weld types and methodology information.

-- Jaimerosciano (talk) 22:58, 5 January 2022 (CET)

• It is suggested to place two containers, one containing the fluid at room temperature and the other containing the fluid obtained at high temperature. This is because if both fluids are mixed in the same container, the efficiency of the Solar Water Heater is lost.

• The curves and descents in the pipes are subtracting energy to the fluid therefore the system needs a pump that provides the impulse for the circulation of the water.

Part number 1.2 -- Jaimerosciano (talk) 23:00, 5 January 2022 (CET)

indicate angle thickness